06-03-2011, 10:29 PM
Hi All,
This evening was the first opportunity I've had to try some old test gear that I have recently purchased - a tektronix T935A 'scope, an HP39999A waveform generator and an Avo HF134 signal generator.
I started off with the Avo connected to the 'scope - flatline no matter what! I then connected the HP waveform generator. All ok here, the 'scope has a crisp display and the waveform generator working well in its 3 function modes (sinewave/sawtooth/squarewave).
Therefore, no problems with the 'scope and the generator. I re-attached the Avo - still flatline.
I suppose the obvious thing to do is to attached this to a radio but I would have thought that I would have some output through the scope
Any suggestions and comments - am I being a thicko and have missed the obvious?
Rob
This evening was the first opportunity I've had to try some old test gear that I have recently purchased - a tektronix T935A 'scope, an HP39999A waveform generator and an Avo HF134 signal generator.
I started off with the Avo connected to the 'scope - flatline no matter what! I then connected the HP waveform generator. All ok here, the 'scope has a crisp display and the waveform generator working well in its 3 function modes (sinewave/sawtooth/squarewave).
Therefore, no problems with the 'scope and the generator. I re-attached the Avo - still flatline.
I suppose the obvious thing to do is to attached this to a radio but I would have thought that I would have some output through the scope
Any suggestions and comments - am I being a thicko and have missed the obvious?
Rob
if all else fails...read the instructions!
