19-08-2021, 03:07 PM
Thanks Jeffrey, your ideas sound plausible. by the way, the diodes are fitted only to the X axis plate circuits.
Today I have improved the HT smoothing and tried the Y circuits with and without the diodes. Having them fitted does improve the Y shift response.
A side effect due perhaps to the resistors on their way to infinity and differences on the diode characteristics is that the trace centre line moves as the signal level is increased. This doe characteristic does not completely disappear with the diodes removed but it is less noticeable.
I also linked the timbase pulse to the Z input, this gives a nice trace without the flyback being visible.
It maybe worthwhile changing the high value resistors and capacitors, maybe even replacing the diodes, or I could just leave well alone.
All the critical components seem ok, some even look to have been changed already by the PO.
I wonder what vintage those diodes are, there is a right hotchpotch of components, some are marke AM. The rectifier valves are 4 pin pre-octal types.
Kind regards, David.
Excuse the scrappy notes... shows the valves used, approx measured in circuit resistor values, CRT divider chain and EHT supply.
Today I have improved the HT smoothing and tried the Y circuits with and without the diodes. Having them fitted does improve the Y shift response.
A side effect due perhaps to the resistors on their way to infinity and differences on the diode characteristics is that the trace centre line moves as the signal level is increased. This doe characteristic does not completely disappear with the diodes removed but it is less noticeable.
I also linked the timbase pulse to the Z input, this gives a nice trace without the flyback being visible.
It maybe worthwhile changing the high value resistors and capacitors, maybe even replacing the diodes, or I could just leave well alone.
All the critical components seem ok, some even look to have been changed already by the PO.
I wonder what vintage those diodes are, there is a right hotchpotch of components, some are marke AM. The rectifier valves are 4 pin pre-octal types.
Kind regards, David.
Excuse the scrappy notes... shows the valves used, approx measured in circuit resistor values, CRT divider chain and EHT supply.







