06-06-2021, 04:33 PM
Radio Fixer Wrote:...soaking in a white vinegar and water solution.
Having read Gary's post and because it was in a very dirty state I thought to try a soak in the washing soda followed by the vinegar treatment if necessary. I wasn't confident enough to go straight into doing the triple gang one, but picked on another grotty example from the junk box.
I did end up removing the rotor from the frame, the only thing I needed to do that was loosening the pressure screw for the back of the rotor shaft as my victim had a very helpful rotor contact system that doesn't have to be removed first, that normally means removing a rivet.
We don't have a dish washer or USC so the cleaning was a manual enterprise. I used a piece of felt to clean the loose muck between the plates after the first soak. Second time I re heated the solution on a camping stove, stirring the brew as I did so. After this there still appeared to be some corrosion spots between the rotor plates, so the soda solution was changed for vinegar, and the capacitor given another slosh round while heating. If nothing else the old saucepan I used is now the cleanest one we have! After a good rinse in boiling water the visible corrosion has now gone, so I'm claiming it a success. The parts are now sitting on top of the hot water cylinder to dry before being reassembled.
Next I'll try the Alubrite on another victim, see how that goes before moving on to the main feature of the big triple...






