04-06-2021, 07:38 AM
(03-06-2021, 09:02 PM)Kalee20 Wrote: Finally, when dry, relubricate the bearings - I use clock oil for a sliding bearing, and molybdenum disulphide grease thinned down with paraffin for ball-bearings, applied with a small medical syringe to get it where it's needed. The paraffin evaporates of course, but by then the grease is where it's needed.
The points about rinsing and clock oil are important. Rinsing, obviously, to remove any non-PH 7 contaminants (should ideally use deionised water, but not that important) but, for those that don't know, modern watch/clock oil does not dry and become tacky with time - they are synthetic oils, typically silicone-based, and are very thin. The traditional watch oils were a combination of neatsfoot and mineral oils which become gummy over time and could be acidic thus damaging metal - watchmakers had a nice business in regularly cleaning mechanical watches because of this! Neatsfoot oil is made from the bones & feet of cattle, "neat" being an OE term for cattle, i.e. not one for vegetarians or vegans etc...
sıʌǝɹq ɐʇıʌ `ɐƃuol sɹɐ
ʞɔıu
ʞɔıu







