08-02-2021, 08:10 PM
Thanks Ed
I'm just a wee bit concerned about understanding to add a front end valve to the circuit to overcome the original 'issue' in the poor design (far too much background noise). It does not appear to be much work but its knowing exactly where to break it in to the existing circuit.
I'm sure that I will get there..........I don't want to pay around £2000 for an original amp which will still have the same problem, hence why I'd want to build my own version.
I've ordered a couple of 6AV6's and the price is vastly different to that of an ECC83 - about £6 compared to say £80 to £100 for a NOS valve.....criminal, especially when you only need to use half of it operationally.
Best Regards
Rob
I'm just a wee bit concerned about understanding to add a front end valve to the circuit to overcome the original 'issue' in the poor design (far too much background noise). It does not appear to be much work but its knowing exactly where to break it in to the existing circuit.
I'm sure that I will get there..........I don't want to pay around £2000 for an original amp which will still have the same problem, hence why I'd want to build my own version.
I've ordered a couple of 6AV6's and the price is vastly different to that of an ECC83 - about £6 compared to say £80 to £100 for a NOS valve.....criminal, especially when you only need to use half of it operationally.
Best Regards
Rob
if all else fails...read the instructions!







