20-07-2020, 09:58 AM
The resistance across the base of the EZ81 pins 1 & 7 is 51.7R.
I did set the oscilloscope probe to x10 as was indicated. I ddo have to say that the T935a volts/div setting is hard to interpret. The manual indicates that the reading must be taken from the x10 (I assume the light grey) slot on that side.
I did set the oscilloscope probe to x10 as was indicated. I ddo have to say that the T935a volts/div setting is hard to interpret. The manual indicates that the reading must be taken from the x10 (I assume the light grey) slot on that side.
if all else fails...read the instructions!
