11-11-2019, 09:30 PM
You can now see where the TCC cap has pulled away from the board. I'm surprised it hasn't been held down given the size its just held by the soldered joints.
Mark - you are spot on re the resistors.
Whats you thoughts in general - apart from the flux left over from the soldering (!!) I dont think it appears too bad, but what do I know?
Best Regards
Mark - you are spot on re the resistors.
Whats you thoughts in general - apart from the flux left over from the soldering (!!) I dont think it appears too bad, but what do I know?
Best Regards
if all else fails...read the instructions!







