11-11-2019, 10:17 AM
If the electrolytics are Plessey rather than Mullard I'd replace on sight.
If a PCB track is in trouble or even missing I'd normally use a bit of tinned copper wire to reinforce it. If there's a big component on the board, such as a large axial capacitor, I'd consider drilling 2 holes and using a tie-wrap to reduce stress on the solder joints. Always provided that the holes won't damage anything else.
If a PCB track is in trouble or even missing I'd normally use a bit of tinned copper wire to reinforce it. If there's a big component on the board, such as a large axial capacitor, I'd consider drilling 2 holes and using a tie-wrap to reduce stress on the solder joints. Always provided that the holes won't damage anything else.
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv
