Taylor Model 60 signal generator

[Sinewave]

Two feedback wires to grid of audio triode (one wire will be earthed?), two for audio triode anode (HT to anode) and one for RF triode HT feed = 5 wires. The RF Triode HT modulation might not share the same HT point as the Audio Triode "primary" winding.

So you need five connections and six isn't extraordinary. My replacement transformer actually has two 0-115 primaries for 230V rather than a centre tap, so they can be in parallel on 110-120 mains.

Here's a photo of the Tx. I'm just trying to work out which is which, how to illustrate this on a drawing. I will need to mark everything up to test to determine windings, tappings etc, but I probably won't be able to go that far tonight.

The caps to the left of pin 1 are just using the Tx for support, but not connected at that point, but they are connected to pin 4.



I am still working on the drawing of the sig gen. Thanks for your help so far.