24-03-2019, 07:26 AM
The OP's project is a DAC90a, sufficiently simpleand accessible that the replacement methodology hardly matters. Though anyone can make a mistake, however experienced. Hence the invaluable advice to take notes and photos.
Mike (Crackle) has made the point that where access is difficult it's sensible to replace suspect parts in the right order. Or where it could easily damage the set if you did them individually. An example is a Thorn 2000 TV where all the small electrolytics really need changing and you'd wreck the PCB edge connectors if you did them one at a time. But this sort of set isn't (or shouldn't be) beginners' territory.
Mike (Crackle) has made the point that where access is difficult it's sensible to replace suspect parts in the right order. Or where it could easily damage the set if you did them individually. An example is a Thorn 2000 TV where all the small electrolytics really need changing and you'd wreck the PCB edge connectors if you did them one at a time. But this sort of set isn't (or shouldn't be) beginners' territory.
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv







