04-03-2019, 06:16 PM
Stephen
The FPGA should program/reprogram without any problem while connected to the Hedghog PCB. The LED's wont flash only because they are disabled when the FPGA board is installed in the Hedghog PCB. Grounding pin79 of the FPGA disables the LED's.
Getting access to the JTAG connector is the biggest problem.
Frank
The FPGA should program/reprogram without any problem while connected to the Hedghog PCB. The LED's wont flash only because they are disabled when the FPGA board is installed in the Hedghog PCB. Grounding pin79 of the FPGA disables the LED's.
Getting access to the JTAG connector is the biggest problem.
Frank
