27-05-2011, 04:23 PM
Some updates on this chaps,
I have finally finished the construction, having been otherwise distracted.
Having put a load of some 6k on the LT side I find the output voltages on this side are 1.4v 1.9v, and 7.1v.
It appears therefore the voltage regulator is doing a good job, of well regulating! T least the voltage output is not differing wildly.
As I have a spare side on the voltage selector switch I may just build some crowbar circuits just in case.
The meter shunts are not quite right, but I only put it in so it looked good, and they are not too far out on the dial.
cheers Mark
I have finally finished the construction, having been otherwise distracted.
Having put a load of some 6k on the LT side I find the output voltages on this side are 1.4v 1.9v, and 7.1v.
It appears therefore the voltage regulator is doing a good job, of well regulating! T least the voltage output is not differing wildly.
As I have a spare side on the voltage selector switch I may just build some crowbar circuits just in case.
The meter shunts are not quite right, but I only put it in so it looked good, and they are not too far out on the dial.
cheers Mark
Keep on Fiddling!
