I have made a start on my new aerial, I hope I am not wasting my energy and money.
The first plan is to install a new dedicated RF earth.
I have been chiselling a channel through the 2m wide concrete path outside the back of the house, from the soft ground to the house wall, just a little bit more to finish now. I plan to lay the earth cable from the new RF earth, in the channel and then put a weak concrete mix over the top.
I am following a convenient crack which goes across the path at this point, which is making it easier, but I still have to keep stopping to rest my wrist from using the club hammer.
My son has also been practising his chucking, and I now have a rope around the base of chimney, I have been looking at it and feeling maybe it is too thin at 5mm, so may decide to pull a thicker rope through, say 8mm.
(the kink in the gutter was caused when the neighbours perfectly good but slightly tatty looking aluminium gutter was replaced with a poorly fitted plastic gutter and they lifted my last section to meet their incorrectly installed one.)
I picked up a Global AT2000 ATU for about £5 at a boot sale last year, Has anyone had experience of these.
Mike
The first plan is to install a new dedicated RF earth.
I have been chiselling a channel through the 2m wide concrete path outside the back of the house, from the soft ground to the house wall, just a little bit more to finish now. I plan to lay the earth cable from the new RF earth, in the channel and then put a weak concrete mix over the top.
I am following a convenient crack which goes across the path at this point, which is making it easier, but I still have to keep stopping to rest my wrist from using the club hammer.
My son has also been practising his chucking, and I now have a rope around the base of chimney, I have been looking at it and feeling maybe it is too thin at 5mm, so may decide to pull a thicker rope through, say 8mm.
(the kink in the gutter was caused when the neighbours perfectly good but slightly tatty looking aluminium gutter was replaced with a poorly fitted plastic gutter and they lifted my last section to meet their incorrectly installed one.)
I picked up a Global AT2000 ATU for about £5 at a boot sale last year, Has anyone had experience of these.
Mike






