18-05-2017, 06:12 PM
A lot of these hobs have a thermal cut-out across the element to protect the glass. They are an Invar rod in a glass tube, the expansion of the glass opens the switch at the end if the pan doesn't take the heat away quickly enough.
An intermittent fault could be, the cut-out, pan too small for the size of the element, pan not flat on the bottom, regulator switch (simmerstat)not staying full on, but seldom the element!
I would inspect the pans used first, they must be a similar size to the heated area, must be flat on the bottom, no recess. Pans that have been used on gas before will not be flat, check with a straight edge.
Sam.
An intermittent fault could be, the cut-out, pan too small for the size of the element, pan not flat on the bottom, regulator switch (simmerstat)not staying full on, but seldom the element!
I would inspect the pans used first, they must be a similar size to the heated area, must be flat on the bottom, no recess. Pans that have been used on gas before will not be flat, check with a straight edge.
Sam.
Boater Sam.







