11-04-2017, 08:53 PM
Hi Craig, hope you had a nice holiday.
1) Bought new components but did not fit.
2) Turned on scope R926 smoked, turned off scope.
3) Removed 3pin plug P126.
4) Turned scope on have primary voltages, front panel lights on, had thick trace but today heard arcing noise but not sure where from possibly one of the timing neons after this arcing noise lost thick trace.
5) replaced R926 but have not plugged P126 back in yet but I know where it goes.
What would cause R926 to smoke.
1) Bought new components but did not fit.
2) Turned on scope R926 smoked, turned off scope.
3) Removed 3pin plug P126.
4) Turned scope on have primary voltages, front panel lights on, had thick trace but today heard arcing noise but not sure where from possibly one of the timing neons after this arcing noise lost thick trace.
5) replaced R926 but have not plugged P126 back in yet but I know where it goes.
What would cause R926 to smoke.
