08-04-2017, 03:41 PM
Hi back again gents, received all components from mouser.
Decided to turn scope on again before replacing anything.
R926 smoked.
Removed P126 plug.
The left side has an arrow then pins 2/3 then a 2 pin plug to the right 5pins shown on schematic but it is 2 separate plugs.
The red/black wire and pin 2 on the same plug have continuity I can't find where the wires go to on the schematic.
What does the arrow on the plug denote it's a red/black wire?
What would cause R926 to smoke?
Panel lights on and fat trace on display with P126 left plug removed.
Decided to turn scope on again before replacing anything.
R926 smoked.
Removed P126 plug.
The left side has an arrow then pins 2/3 then a 2 pin plug to the right 5pins shown on schematic but it is 2 separate plugs.
The red/black wire and pin 2 on the same plug have continuity I can't find where the wires go to on the schematic.
What does the arrow on the plug denote it's a red/black wire?
What would cause R926 to smoke?
Panel lights on and fat trace on display with P126 left plug removed.
