Fixed it, this little baby stopped the interference dead,
absolutely no interference now when you ground the negative from the PSU. I have yet to test it whilst operating with the printer but I suspect this has done the job.
Ref, is that what you call a common mode choke? if so thanks for the suggestion, and lucky I happened to have one left over from a project where it was not needed in the end.
Thanks
Mike
absolutely no interference now when you ground the negative from the PSU. I have yet to test it whilst operating with the printer but I suspect this has done the job.
Ref, is that what you call a common mode choke? if so thanks for the suggestion, and lucky I happened to have one left over from a project where it was not needed in the end.
Thanks
Mike






