14-02-2017, 09:40 PM
1) Check bases tomorrow agree with you my mistake.
2) Trace zero is mid 'X' axis gnd.
3) Probe 10x.
4) Can't stabilise trigger at the settings in 8.2 manual.
5) Diodes Vr935, Cr931 tested using Dmm on continuity and diode settings. Tested other diodes in vicinity they tested ok.
2) Trace zero is mid 'X' axis gnd.
3) Probe 10x.
4) Can't stabilise trigger at the settings in 8.2 manual.
5) Diodes Vr935, Cr931 tested using Dmm on continuity and diode settings. Tested other diodes in vicinity they tested ok.
