29-12-2016, 05:43 PM
I may abort. I got the board free although to remove it I'd need to clip a few wires otherwise they would pull off. The tuner would have to be desoldered. Sure, with care, it's doable and it allows me to tidy up the board and better change the caps.
However, at this stage I can easily put it back together and no harm done. Then when I gain more experience I can resume the project.
Refugee, I will test the track a bit more as it's obvious it's a bit aged. I do have full access to the tracks but the wiring under the waveband knobs is out of range. You can see wires disappear below between the mech and upper board.
Not much else to add.
However, at this stage I can easily put it back together and no harm done. Then when I gain more experience I can resume the project.
Refugee, I will test the track a bit more as it's obvious it's a bit aged. I do have full access to the tracks but the wiring under the waveband knobs is out of range. You can see wires disappear below between the mech and upper board.
Not much else to add.
