27-11-2016, 02:00 PM
OK 
So let's look at the second stage first of all.
And to keep it really simple, let's remove the feedback network (C4, C5, R8, R9) completely.
That leaves a conventional valve stage with a bypassed cathode resistor. So that stage will have a pretty high voltage gain. Not as much as an op-amp, but high...
But what happens when the feedback network is introduced?
In fact, let's just use a single resistor in place of those RC networks - just for understanding.
With that done, C3 (either end - this is signal) becomes a virtual earth. If you try to lift the voltage there, the anode voltage falls, and via the feedback resistor, it attempts to counteract this lifted voltage, hopefully pulling it back down to where it initially was.
Likewise, if you try to lower the voltage at C3, the anode voltage will rise, and the feedback resistor will try to counteract the fall.
So whatever signal you apply at C3, the negative feedback fights it. If the valve stage had infinite gain, it would win all the time (until the anode voltage clips). With a 'scope attached to C3, you'd see hardly any signal, if any.
Does all that make sense?
So let's look at the second stage first of all.
And to keep it really simple, let's remove the feedback network (C4, C5, R8, R9) completely.
That leaves a conventional valve stage with a bypassed cathode resistor. So that stage will have a pretty high voltage gain. Not as much as an op-amp, but high...
But what happens when the feedback network is introduced?
In fact, let's just use a single resistor in place of those RC networks - just for understanding.
With that done, C3 (either end - this is signal) becomes a virtual earth. If you try to lift the voltage there, the anode voltage falls, and via the feedback resistor, it attempts to counteract this lifted voltage, hopefully pulling it back down to where it initially was.
Likewise, if you try to lower the voltage at C3, the anode voltage will rise, and the feedback resistor will try to counteract the fall.
So whatever signal you apply at C3, the negative feedback fights it. If the valve stage had infinite gain, it would win all the time (until the anode voltage clips). With a 'scope attached to C3, you'd see hardly any signal, if any.
Does all that make sense?







