14-11-2016, 01:46 PM
I'm not convinced you need to match them at all.
The amp should have emitter resistors - usually 0.2 ohms or thereabouts. These drop enough voltage across them to "swamp" the small differences in Vbe and promote equal current sharing.
Remember - it's the Vbe that matters, not Hfe. Just look at how much Hfe varies with collector current and temperature. No sane designer comes up with products that require specific values of Hfe.
Even if the sharing was really unequal, a single pair of those transistors would be good for around 200 watts into 8 ohms.
If you want to measure Hfe, in terms of gear you need nothing more than a DC power supply (a bench power supply is best), and two multimeters. A power resistor forms a collector load, in series with one DMM, while a potentiometer and a resistor or two provides the base current (second DMM measures this). This approach gives you complete flexibility about which collector current you choose to measure at. No need to go higher than an amp IMHO.
You don't need to put a high voltage across the transistor - just a couple would do, so that you know you're not saturating it. And your bench power supply will have a current limit (perhaps adjustable), so you won't blow up the transistors. Just keep an eye on their temperature if you're using currents measured in amps - a heat sink might be wise.
But like I said, I wouldn't bother. Just bung them in and test (via a lamp limiter first of all - the PSU in the amp will give a lot more energy than a typical bench PSU). Once all is well, do some power testing and make sure they are all running at about the same temperature. A cheap IR thermometer is all you need for that. Yes, they are probably all on a common heat sink, but the top of the plastic case will be much hotter than the heat sink, and will be a closer approximation to the junction temperature. Job done
Good luck - amplifiers like that are not for the faint-hearted
The amp should have emitter resistors - usually 0.2 ohms or thereabouts. These drop enough voltage across them to "swamp" the small differences in Vbe and promote equal current sharing.
Remember - it's the Vbe that matters, not Hfe. Just look at how much Hfe varies with collector current and temperature. No sane designer comes up with products that require specific values of Hfe.
Even if the sharing was really unequal, a single pair of those transistors would be good for around 200 watts into 8 ohms.
If you want to measure Hfe, in terms of gear you need nothing more than a DC power supply (a bench power supply is best), and two multimeters. A power resistor forms a collector load, in series with one DMM, while a potentiometer and a resistor or two provides the base current (second DMM measures this). This approach gives you complete flexibility about which collector current you choose to measure at. No need to go higher than an amp IMHO.
You don't need to put a high voltage across the transistor - just a couple would do, so that you know you're not saturating it. And your bench power supply will have a current limit (perhaps adjustable), so you won't blow up the transistors. Just keep an eye on their temperature if you're using currents measured in amps - a heat sink might be wise.
But like I said, I wouldn't bother. Just bung them in and test (via a lamp limiter first of all - the PSU in the amp will give a lot more energy than a typical bench PSU). Once all is well, do some power testing and make sure they are all running at about the same temperature. A cheap IR thermometer is all you need for that. Yes, they are probably all on a common heat sink, but the top of the plastic case will be much hotter than the heat sink, and will be a closer approximation to the junction temperature. Job done

Good luck - amplifiers like that are not for the faint-hearted







