07-11-2016, 12:28 PM
(This post was last modified: 07-11-2016, 12:31 PM by Diabolical Artificer.)
Re; calculating values for RC filters, when I built this amp I used a 330k R for the EL84's g1 off the top of my head. I thought I'd actually calculate it. AFAIK this R is there to keep g1 @ 0v and the datasheet usually has a g1 max in this case 300k, so I've bogged up here.Anyway, I think we find the value thus, we want Rg1 to be big as poss so we don't dissapate the power of the signal from our voltage amp, so lets say we use a 220k for Rg1, using 1/(2 x pi x f x Rg1) to find out the value of the coupling R from V1's anode, I get 1.4 etc ^ -8 for a roll off of 50hz (the OPT isn't going to go lower), which if I'm right means we use a 1n cap, right? This value seems very low, most amps I've seen use a 0.XXX or 0.0XXu.
So I got a 1000p/1n cap and a 220k R and connected my sig gen + to one end of the cap, with the R and scope probe to the other with the scope and sig gen ground/black leads connected to the other end of the R, I then swept up from 15hz to 50khz. There was attenuation below 50hz, but the amplitude remained low up to about 1khz and at 1k it was 0v, the signal then went up in amplitude as the frequency rose and remained more or less constant. I tried a few other experiments with different RC values and got similar results, at 1k the signal bottomed out at 0v.
Our RC filter/s is behaving more like a notch filter than a high pass filter.
Puzzled, Andy.
So I got a 1000p/1n cap and a 220k R and connected my sig gen + to one end of the cap, with the R and scope probe to the other with the scope and sig gen ground/black leads connected to the other end of the R, I then swept up from 15hz to 50khz. There was attenuation below 50hz, but the amplitude remained low up to about 1khz and at 1k it was 0v, the signal then went up in amplitude as the frequency rose and remained more or less constant. I tried a few other experiments with different RC values and got similar results, at 1k the signal bottomed out at 0v.
Our RC filter/s is behaving more like a notch filter than a high pass filter.
Puzzled, Andy.







