06-11-2016, 06:22 AM
I think though that for the most part, the single-ended component (common-mode or L-R signal) would be of lesser magnitude than the push-pull component (differential of L+R signal), and that the latter would very rarely approach zero. Then the net effect of the signal-dependent varying load distribution between the push-pull and single-ended transformer primaries would be more akin to that of sliding the UL screen grid tapping points. Given that the conventional wisdom is that the UL “benefit curve” is reasonably flat over the range from around 20% to around 50% tapping point, in practice the problem may be milder than the extreme-case analysis indicates, particularly if a tapping at the lower end is used. It falls into something of a grey area, but if we can think of this possibility today, then the chances are that someone thought of it back in the late 1950s and also did some work on it, at least to the go/no go stage.
Another article on orthogonal amplifiers, and one which addresses some of the obvious questions, is:
“Single Push-Pull Stage for Both Stereo Channels”; Radio & Television News for 1959 January, page 48ff, available here: http://www.americanradiohistory.com/Arch...959-01.pdf.
Cheers,
Steve
Another article on orthogonal amplifiers, and one which addresses some of the obvious questions, is:
“Single Push-Pull Stage for Both Stereo Channels”; Radio & Television News for 1959 January, page 48ff, available here: http://www.americanradiohistory.com/Arch...959-01.pdf.
Cheers,
Steve







