02-11-2016, 10:44 AM
Quote:Mark is right about the input stage, for a modern AC source 10k ish is about right. I could have popped a 1meg pot on it but read somewhere that this is too high a value. I used this formula to find C in - 1/(2 x pi x f x R) ... 1 / (6.28 x 1* x 50000) = 3.184713376 -6, therefore a 3u cap is what I used. * Why 1? We want to block DC and pass all frequencies over DC.
All this is really very uncritical. With a high level low impedance source almost anything will work well and not degrade performance significantly.
It's also time for a note about excessive precision. You've specified the values in the formula to a maximum of 3 significant figures yet you've given the result to umpteen, simply because the cacluator says so. This is spurious precision. you have quite rightly roundedthe result to 3. But even this has some implications. The nearest common value caps are 2.2uF and 4.7uF. These electrolytics will have huge tolerances, often as much as -10% to + 50%. And it doesn't matter here!
It really doesn't matter if the frequency response is down to 1Hz or 10Hz as the output transformer won't work that low. Neither will the speaker. Using 3 for pi is perfectly adequate too. You could use a 220n cap, roll off at about 12Hz and it would be fine. I doubt you even notice using a 100n cap. if this is a learning exercise why not try it and see. THough be careful not to delude yourself into hearing a difference.
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv







