14-10-2016, 10:36 AM
Managed to do a bit of testing this morning, the first thing I found when I scoped the left channel OP was a 700- ish khz @ 500mV P-P, that is according to my counter. I went and tested it anyway to see what happens to the DC rails on full volume, they went down a bit as expected. However whilst testing I was getting 20 odd volts RMS at the speaker OP. I switched off to unload some video's I'd taken of my exploits, switched on to measure what happens to the input signal and only got 6v RMS. Input sig (120mV) goes down a tad in both cases at full bore.
One other issue I've found is if I go to measure the voltage on the emmiter of Q705 which is the next Q after the LTP/diiff input, with the amp powered through a LL, the lamp glows brightly. The same is true if I touch it's base. All components in that region EG C708/RH06/Q719/R711/R707 are ok, as are the DC voltages on Q705 AFAICT.
Saw TerryKC yesterday, he said to look at the effected channel's FB network. Not knowing a great deal about NFB, apart from the fact that we feed back a bit of the OP signal, I'm not sure what to look for apart from checking C705/R709. I'll look at the zobel components too, C717/R727.
Apart from that, i'm stumped as to why both channels have normal OP power one minute, the next not. I am going to go and resolder every joint though.
Andy.
One other issue I've found is if I go to measure the voltage on the emmiter of Q705 which is the next Q after the LTP/diiff input, with the amp powered through a LL, the lamp glows brightly. The same is true if I touch it's base. All components in that region EG C708/RH06/Q719/R711/R707 are ok, as are the DC voltages on Q705 AFAICT.
Saw TerryKC yesterday, he said to look at the effected channel's FB network. Not knowing a great deal about NFB, apart from the fact that we feed back a bit of the OP signal, I'm not sure what to look for apart from checking C705/R709. I'll look at the zobel components too, C717/R727.
Apart from that, i'm stumped as to why both channels have normal OP power one minute, the next not. I am going to go and resolder every joint though.
Andy.







