10-10-2016, 08:35 AM
Hi Andy.
Sounds like you have covered more or less everything.
A few small things do come to mind.
You say you have checked the smoothing capacitors, is that for value or for ESR? Why I ask is that you can often get an accurate value reading but a poor ESR value. It could be that.
Soldering...... Now I have also had issues with soldering especially with Sony, not the familiar "dry joint" but where the joint looks perfect but the copper track of the print has not been tinned and there is only a friction connection to the joint, these need a good old prod to show up.
Transistors......... Yes they can fail under stress, go O/C until the power has been removed and will then work seemingly fine until you crank up the volume, usually driver or outputs do this but often accompanied by a noticeable crack in the speaker.
Good Luck
Sounds like you have covered more or less everything.
A few small things do come to mind.
You say you have checked the smoothing capacitors, is that for value or for ESR? Why I ask is that you can often get an accurate value reading but a poor ESR value. It could be that.
Soldering...... Now I have also had issues with soldering especially with Sony, not the familiar "dry joint" but where the joint looks perfect but the copper track of the print has not been tinned and there is only a friction connection to the joint, these need a good old prod to show up.
Transistors......... Yes they can fail under stress, go O/C until the power has been removed and will then work seemingly fine until you crank up the volume, usually driver or outputs do this but often accompanied by a noticeable crack in the speaker.
Good Luck






