05-05-2011, 03:28 PM
Ok guys, a further update,
the PCB is now in the cabinet, I made a switch supply for the LT side so the actual eliminator gives 1.4, 2 and 7.5 volts.
I had to shunt through resistors, the same for the meter to get the correct voltages and readings.
Just need to wire up the mains to the switch and neon then to the Tx.
Oh and redo the labelling.
cheers Mark
the PCB is now in the cabinet, I made a switch supply for the LT side so the actual eliminator gives 1.4, 2 and 7.5 volts.
I had to shunt through resistors, the same for the meter to get the correct voltages and readings.
Just need to wire up the mains to the switch and neon then to the Tx.
Oh and redo the labelling.
cheers Mark
Keep on Fiddling!
