10-01-2016, 08:10 PM
Well done on that Gary.
The valve-holder does look very grotty from the pics on the VRF, so I do hope one turns up for you.
If not, you might wish to try Langrex:
http://www.langrex.co.uk/valve-bases.html
You'll definitely get a new ceramic one from Tube Depot for just $4.95, but I don't know what shipping would cost:
https://www.tubedepot.com/products/8-pin...cx400a-etc
As others have pointed out, your socket is supported on two rubber grommets as a precaution against 'microphony'. It may be unnecessary, but on the other hand, while you're at it, it's no big deal to fit a couple of new ones, because clearly, Cossor thought it necessary at the time.
Good luck with it!
The valve-holder does look very grotty from the pics on the VRF, so I do hope one turns up for you.
If not, you might wish to try Langrex:
http://www.langrex.co.uk/valve-bases.html
You'll definitely get a new ceramic one from Tube Depot for just $4.95, but I don't know what shipping would cost:
https://www.tubedepot.com/products/8-pin...cx400a-etc
As others have pointed out, your socket is supported on two rubber grommets as a precaution against 'microphony'. It may be unnecessary, but on the other hand, while you're at it, it's no big deal to fit a couple of new ones, because clearly, Cossor thought it necessary at the time.
Good luck with it!
Regards, David.
BVWS Member.
G-QRP Club Member 1339.
'I'm in my own little world, but I'm happy, and they know me here'
BVWS Member.
G-QRP Club Member 1339.
'I'm in my own little world, but I'm happy, and they know me here'







