01-01-2016, 12:52 PM
I've managed to identify the other two valves, Mullard PM1 HF (RF amp) & Mullard PM2 (1st AF) had already been identified, I initially knew that the Det valve was a Mullard but wasn't sure of the type, shining an LED light at various angles revealed that it was a Mullard PM1 LF, it's an early one, the Mullard logo is the antenna & inductor.
The AF output valve was more of a challenge, no ID marks whatsoever, however the anode shape is trapezium type, only one I could find that fits the anode bill with the same style of valve base (which is open at the bottom) is the Cossor Stentor two, 100% as I can be that this is the one:
http://www.r-type.org/exhib/aat0008.htm
I'm still with the "La Radio Industrie" theory on the ID of the receiver, they appear to have been a more specialist manufacture, there equipment was associated with the aero industry, they did some domestic receivers back then but not many so far as I can find out, later they were involved with early TV systems/components etc
Lawrence.
The AF output valve was more of a challenge, no ID marks whatsoever, however the anode shape is trapezium type, only one I could find that fits the anode bill with the same style of valve base (which is open at the bottom) is the Cossor Stentor two, 100% as I can be that this is the one:
http://www.r-type.org/exhib/aat0008.htm
I'm still with the "La Radio Industrie" theory on the ID of the receiver, they appear to have been a more specialist manufacture, there equipment was associated with the aero industry, they did some domestic receivers back then but not many so far as I can find out, later they were involved with early TV systems/components etc
Lawrence.







