Gave the receiver a quick scrub up with some meths and wax polish to get a rough idea what it would look like if restored, the front panel and knobs seem to respond to the treatment ok, managed to get a shine on the front panel, only cleaned the front face of the knobs, the cabinet base is hanging, the cabinet sides and top came up good to what they were, some staining, not sure how deep, if it's deep I would be inclined to leave it at that, all part of the history, I think the salvageable wood would respond to a full strip and re polish.
The white paint in the engraving had mostly turned to white dusty stuff, the cleaning has removed some of that, the engraving is not too clear as a result, the depth of the engraving seems not to have altered so might respond to the paint stick treatment to highlight it again, cleaning the crud off revealed a couple more engraved words and some circular arrows above the rheostat knob..."Chauff Aug"...crank up the heat or something like that. I think the front panel and the valve panel would come up very well if all the component bits were removed to give decent access.
The bit of the control panel that was broken off (Top RH side) has just been loose laid back in position, the break looks clean so should glue up ok if required.
Note: The six holes in the base line up with the six terminals on the control panel.
Lawrence.
The white paint in the engraving had mostly turned to white dusty stuff, the cleaning has removed some of that, the engraving is not too clear as a result, the depth of the engraving seems not to have altered so might respond to the paint stick treatment to highlight it again, cleaning the crud off revealed a couple more engraved words and some circular arrows above the rheostat knob..."Chauff Aug"...crank up the heat or something like that. I think the front panel and the valve panel would come up very well if all the component bits were removed to give decent access.
The bit of the control panel that was broken off (Top RH side) has just been loose laid back in position, the break looks clean so should glue up ok if required.
Note: The six holes in the base line up with the six terminals on the control panel.
Lawrence.







