26-12-2015, 07:45 PM
Alan, Re the timber: the cabinets top panel is ok, that would go again, the rear and the side panels have rotted out on all the bottom edges, the base is the real basket case a decent chunk of it has simply rotted away, that's the bit in the front LH corner, there are strands of rot fungus on the base and the base feels unusually light, the plywood panel inside the cabinet just off the back is also shot, the roll top slats are in the main ok and would go again.
So... What would I do with the cabinet, I would like to think that I could cut all the rot out, give it a good dose of stuff then graft some new bits in, that would provide continuity for its history.....that's the dreamy stuff, in reality it would be simpler to make a new cabinet to the original specifications.
The story so far with receiver: A woman I know was basically being evicted, I was helping to clear one of the sheds out, most of the stuff was being burnt on a bonfire, the receiver nearly ended up on it, I spotted the tops of the valves just in time, I offered to store it in our house to dry out and to see If I could find out anything about it.
At the moment I don't know what she would want done with it.
Lawrence.
So... What would I do with the cabinet, I would like to think that I could cut all the rot out, give it a good dose of stuff then graft some new bits in, that would provide continuity for its history.....that's the dreamy stuff, in reality it would be simpler to make a new cabinet to the original specifications.
The story so far with receiver: A woman I know was basically being evicted, I was helping to clear one of the sheds out, most of the stuff was being burnt on a bonfire, the receiver nearly ended up on it, I spotted the tops of the valves just in time, I offered to store it in our house to dry out and to see If I could find out anything about it.
At the moment I don't know what she would want done with it.
Lawrence.







