Not sure Alan, not really done much with 1920's valves, if they were bright emitters that were fitted it would give the option of reducing the filament voltage, I gather that increased the life expectancy of the bright emitter types, from all accounts they had a short life at full whack, I read somewhere that some bright emitters needed more than 2 volts, 3 volts and over being common, that's assuming this receiver had bright emitters, I've no sure way of knowing at the moment, alternatively it might have been fitted with 4 volt dull emitters and the rheostat was used to crank the gain down a bit with the RF amp being a tuned grid, tuned anode circuit, need to find out more if I can to fill in the gaps.
Lawrence.
Lawrence.







