22-12-2015, 08:06 PM
3rd part of the reverse engineering, it's for the 4 pole lever switch, not too bad to work out this one, I've not included a circuit overview with this one as I did with the last, it's not really possible 'till the rest of the circuit is done.
In the three parts so far uploaded the component designations I've added might not always make sense but it suits me as things stand, a full schematic will be next with a more logical set of component designations, either in sections or all together if I can get it all on an A4 sheet:
Lawrence.
In the three parts so far uploaded the component designations I've added might not always make sense but it suits me as things stand, a full schematic will be next with a more logical set of component designations, either in sections or all together if I can get it all on an A4 sheet:
Lawrence.







