02-12-2015, 07:22 PM
Toroidal transformers tend to saturate more easily with DC flowing than conventional types. That's because the geometry of the core is such that the magnetic field is always directed along the core's grain structure. Permeability (and inductance) is highest, but the down side is that DC has most effect.
So, for a single-ended stage it's a no-no. Although, if you try it, you will get something!
As a push-pull stage, however, as long as balance is good, there should be decent performance to be obtained. The killers in output transformers are primary capacitance, and leakage inductance (hurting high-frequency response); and primary inductance (hurting low-frequency response).
If you have a 0-120 / 0-120V dual primary, you effectively have a centre-tapped primary, and you can strip off the secondary and rewind to suit your loudspeaker. Being designed to operate at 120V each half secondary, at 50Hz, you should be OK with bass response down to 74Hz with 250V HT before saturation-induced distortion sets in. (Calculation: 250V HT gives at most 250V peak, or 177V RMS drive to the transformer; and if the transformer does not sturate with 120V RMS at 50Hz it will equally be happy with 177V at 74Hz). At the HF end, the primary self-capacitance may limit response, if the winding extends over more than one layer (modern enamel will easily withstand 120V AC of overlapped ends). And leakage inductance will not be mega low, as there is no sectioning of primary and secondary, though it won't be unduly high either. So treble response ought to be at least reasonable!
One tip - if rewinding the secondary to suit your loudspeaker, ensure the winding i9e evenly spread around the toroid circumference. Bunching turns in one place hurts leakage inductance, and also spoild the zero-external-field property of an ideal toroidal transformer.
So, for a single-ended stage it's a no-no. Although, if you try it, you will get something!
As a push-pull stage, however, as long as balance is good, there should be decent performance to be obtained. The killers in output transformers are primary capacitance, and leakage inductance (hurting high-frequency response); and primary inductance (hurting low-frequency response).
If you have a 0-120 / 0-120V dual primary, you effectively have a centre-tapped primary, and you can strip off the secondary and rewind to suit your loudspeaker. Being designed to operate at 120V each half secondary, at 50Hz, you should be OK with bass response down to 74Hz with 250V HT before saturation-induced distortion sets in. (Calculation: 250V HT gives at most 250V peak, or 177V RMS drive to the transformer; and if the transformer does not sturate with 120V RMS at 50Hz it will equally be happy with 177V at 74Hz). At the HF end, the primary self-capacitance may limit response, if the winding extends over more than one layer (modern enamel will easily withstand 120V AC of overlapped ends). And leakage inductance will not be mega low, as there is no sectioning of primary and secondary, though it won't be unduly high either. So treble response ought to be at least reasonable!
One tip - if rewinding the secondary to suit your loudspeaker, ensure the winding i9e evenly spread around the toroid circumference. Bunching turns in one place hurts leakage inductance, and also spoild the zero-external-field property of an ideal toroidal transformer.







