16-11-2015, 01:48 PM
The BVWS sell 500V electrolytics but you're right, 350V parts in series will do fine. The voltages across the pairs should balance up OK simply because of the way that electrolytics leak slightly. Don't need balancing resistors unless you want to fit bleeds to discharge the caps after switch off.
As for rectifying 5V, you'll get 5 * SQRT(2) = 7.1V off load. But subtract 1 or 2 diode drops depending on whether you're using half or fullwave rectification. Unless you use schottky diodes. It'll need a big smoother (finger in air says 2200u or 4700u) to keep the loaded voltage drop OK. It'll be worse with a halfwave rect.
As for rectifying 5V, you'll get 5 * SQRT(2) = 7.1V off load. But subtract 1 or 2 diode drops depending on whether you're using half or fullwave rectification. Unless you use schottky diodes. It'll need a big smoother (finger in air says 2200u or 4700u) to keep the loaded voltage drop OK. It'll be worse with a halfwave rect.
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv







