13-09-2015, 07:25 PM
(11-09-2015, 03:43 PM)Nowhere-Man Wrote: I put a plug on the inverter as it's shown in the booklet and just plugged it in. So, the inverter is secondary and used as an appliance. The battery is reluctant to charge. It may or may not have sulphated but sometimes it's possible to get a charge. Time will tell. I have to step over it as it's on the floor at the moment charging.Please clarify the above:
It sounds like you fitted a 13 amp plug to the 240v output of the inverter, was this with the view to plugging it into the ships 240v mains circuit.
Highly dangerous, anyone reading this should NEVER attempt to do this.
(11-09-2015, 03:43 PM)Nowhere-Man Wrote: One thing I discovered was I think it's a ferro resonant charger because the booklet shows a max current of 10 amps at charge yet lower voltage. When the voltage goes up to 13, current drops. There was a debate with a friend about cable size but I ended up fitting a very high amps cable, mainly to accommodate any surge or high load across the inverter.Unlikely, for leisure use in the 90's, it is more likely to be a constant voltage charger, or switched mode 3 stage charger. (bulk charge equalise, float)
(11-09-2015, 03:43 PM)Nowhere-Man Wrote: This is a modified sine wave unit. Not sure how my radio would work on it.Modified sine wave is more or less square wave. It may work, but in my experience with valve radios on a modified sine wave inverter there is so much "noise and interference" that the AGC of the radio will be turned full on and it will have difficulty picking up any stations on MW or LW.
Mike






