08-09-2015, 12:41 PM
Once that snapped belt was in the bin I did indeed make some progress. My test set has proved its worth and I have identified all the inputs.
The tape input is just a low level line input and is not a tape head input as is printed on the front panel.
The magnetic gram input is indeed for a magnetic cartridge and has the correct tone correction for this. The adapter for my signal generator proved its worth for checking this out.
I have now replaced the diode on the power indicator and it is now working correctly with the EM84 giving full deflection just before the audio output begins to distort. I even managed to find an exact replacement for the diode in my box of vintage diodes.
The speaker connectors do indeed need to be replaced.
In my own stash of components I have some switched sockets that are stereo so they have three contacts that are all switched. This means that they can be wired to use two methods to stop the amplifier from running without a speaker. The switches on these sockets are much stronger than the ones on the two pin DIN sockets. Just ask anyone whom owns a radio with a two pin DIN socket for external speaker and they will tell you how much trouble they are.
Those DIN sockets are such a bad fit that you can see a little bit of the oscilloscope display through the gap by the connector even before we worry about reliability.
These switched sockets will do the job just as well as latching or screw in types with the output transformer protected in two different ways.
The main switch will put the load resistor into the circuit as a dummy speaker and the third connection that would not otherwise be used will be used to cut the input to the amplifier. This means that two things would have to go wrong for there to be a problem.
The tape input is just a low level line input and is not a tape head input as is printed on the front panel.
The magnetic gram input is indeed for a magnetic cartridge and has the correct tone correction for this. The adapter for my signal generator proved its worth for checking this out.
I have now replaced the diode on the power indicator and it is now working correctly with the EM84 giving full deflection just before the audio output begins to distort. I even managed to find an exact replacement for the diode in my box of vintage diodes.
The speaker connectors do indeed need to be replaced.
In my own stash of components I have some switched sockets that are stereo so they have three contacts that are all switched. This means that they can be wired to use two methods to stop the amplifier from running without a speaker. The switches on these sockets are much stronger than the ones on the two pin DIN sockets. Just ask anyone whom owns a radio with a two pin DIN socket for external speaker and they will tell you how much trouble they are.
Those DIN sockets are such a bad fit that you can see a little bit of the oscilloscope display through the gap by the connector even before we worry about reliability.
These switched sockets will do the job just as well as latching or screw in types with the output transformer protected in two different ways.
The main switch will put the load resistor into the circuit as a dummy speaker and the third connection that would not otherwise be used will be used to cut the input to the amplifier. This means that two things would have to go wrong for there to be a problem.







