The type of connectors my amplifiers have were there when I got them and I also had to grab a box of plugs to go with them when I got the amps.
They also fit ex military comms receivers and are very expensive on the web now. I don't have enough chassis sockets.
Latching sockets are still made and are a lot easier to get.
https://www.google.co.uk/?gws_rd=ssl#q=XLR+connector
The chassis fittings are normally sold at the places that sell the plugs.
The existing 2 pin DIN sockets have a built in switch that is very prone to failure and a protection resistor mounted behind them.
The best way I see of fixing the speaker sockets is to go for the 1/4 inch ones used on guitar amps as these have a much stronger switch and the existing protection resistor can be retained. The existing holes in the chassis also look closer to the 1/4 inch chassis fitting.
I have completed and tested my test set but got called away this afternoon before I could complete the second half of the preamp.
They also fit ex military comms receivers and are very expensive on the web now. I don't have enough chassis sockets.
Latching sockets are still made and are a lot easier to get.
https://www.google.co.uk/?gws_rd=ssl#q=XLR+connector
The chassis fittings are normally sold at the places that sell the plugs.
The existing 2 pin DIN sockets have a built in switch that is very prone to failure and a protection resistor mounted behind them.
The best way I see of fixing the speaker sockets is to go for the 1/4 inch ones used on guitar amps as these have a much stronger switch and the existing protection resistor can be retained. The existing holes in the chassis also look closer to the 1/4 inch chassis fitting.
I have completed and tested my test set but got called away this afternoon before I could complete the second half of the preamp.







