(04-09-2015, 03:58 PM)Nowhere-Man Wrote: In Chas Miller's Radio And Audio handbook, he devotes a few paragraphs to Silicon rectifiers. He basically recommends starting with a 1 K series resistor or even up to 2 K. The major point he makes is that the DC Ripple voltage that emerges at the silicon diode cathodes will be 1.414 the A.C. 260 volts. That would be 360 D.C. roughly.When you did this test you had a 10 volt drop across your 220 ohm resistor, so there is something on the circuit drawing 45mA of current, probably the valves and the rest of the circuits.
Yesterday, after doing that little job, I decided to retest the voltage at the cathodes of the silicon diodes. I got 290 volts. The other side of my 220 Ohm smoothing resistor I got 280 odd volts. The output tube anode voltage ought to be about 280 so I was happy with the tests.
This is why the HT voltage is not the full 1.414 x 260v or 360 volts. In addition your volt meter will probably not measure the peak ripple voltage.
If you disconnected the rectified and smoothed DC from the rest of the radio circuits then all you should have on the rectified voltage are the smoothing capacitors. The purpose of these capacitors is to smooth out the "ripple" to a more constant voltage, you should then see something more like 360v. (assuming there is no other current drain on the circuit)
Be careful.
Mike






