28-08-2015, 03:45 PM
(27-08-2015, 09:17 PM)Terry Wrote:I'm a bit lost by what my posts have made clear about not restoring the HMV to its original condition?(27-08-2015, 04:24 PM)Nowhere-Man Wrote: I just got back from Maplins and am simply not happy with the pots they have. Too flimsy and modern. I also have a 3 inch shaft on mine and the lugs are much larger and more spaced. I decided to leave it and see if I can get a proper vintage pot and double pole switch. Unless maybe I can repair the old pot.
You may have to accept that the only replacement available to you today is going to be much more modern than you would like but you are not attempting to restore this set to its original condition - your posts have made this very clear - so why does it matter?
You may find something more to your liking here: http://www.partridgeelectronics.co.uk/17Cresistors.htm (scroll down to the bottom) but I haven't done an intensive search of their stock.*
As for component replacement where it is not possible (or advisable) to completely remove the original, I would always leave sufficient wire from the original to bend it back against itself to form a U shaped loop, repeat this on the new component and then hook the two together. Then squeeze together with pliers - both ends - to create a strong mechanical joint before soldering.
* This applies to all pots: if the spindle is longer than required, mark the correct length clearly on the shaft and then cut the spindle to length ensuring that the waste part of the spindle is securely held in a vice. Never, ever, hold the pot in the vice!
I'm aware some people like to stuff original capacitors with new ones but the originals in this case were really too blistered and degraded to bother with that. Sure, I've seen capacitors that are maybe worth re-using for originality but this set has had a fair few Winters on the Moorlands in storage. Apart from that, it will still have the original rectifier and all the original tubes, including the X78 that's quite a good valve to own.
I tested the speaker and it's O.K. The primary transformer seems O.K. although I won't really know till I voltage test it properly in a couple of weeks. Hopefully the valves will be O.K. but fingers crossed.
The GEC was different altogether as it had no rectifier valve or indeed any valves. It will never be an original radio due to that but the main thing is it works and works very well audio-wise.
The HMV does stand a chance of being pretty much the same radio that was used back in 1953 because it's not been tampered with.
I attempted to upload a pic of more work I did today and I'm afraid it's a no go. I took the pic from further away and shrunk it on Microsoft but the pop-up keeps saying it has too many pixels. It seems my FujiFilm camera doesn't seem to much use where size is an issue.







