14-08-2015, 08:44 PM
I agree the heat shrink will continue to shrink and eventually crack. The resistor needs to be in open air so that it can keep cool. The heat shrink will act like a blanket and allow it to get hot. The wires on power resistors need to be looped around a tag at each end.
The only exception to this rule about power resistors is if they are mounted on a spring at the non rectifier end so that the joint melts and the resistor springs away from the rectifier.
Phillips used to use these ping off resistors on some 1950s TV sets.
I have an item of test equipment made by Phillips that has a very early version of this type of thermal fuse on the HT transformer.
The spring is attached to a solder tag that is folded around a copper slug that is slid between the transformer windings and soldered to it. If the transformer gets overloaded the solder melts and the spring pulls the solder tag off. The primary winding is connected to the copper slug and the power is connected to the spring.
It disconnects the power and just leaves a live spring hanging in the area that is insulated with that brown fiber board that is shown folded back for the photo to be taken.
The only exception to this rule about power resistors is if they are mounted on a spring at the non rectifier end so that the joint melts and the resistor springs away from the rectifier.
Phillips used to use these ping off resistors on some 1950s TV sets.
I have an item of test equipment made by Phillips that has a very early version of this type of thermal fuse on the HT transformer.
The spring is attached to a solder tag that is folded around a copper slug that is slid between the transformer windings and soldered to it. If the transformer gets overloaded the solder melts and the spring pulls the solder tag off. The primary winding is connected to the copper slug and the power is connected to the spring.
It disconnects the power and just leaves a live spring hanging in the area that is insulated with that brown fiber board that is shown folded back for the photo to be taken.







