22-07-2015, 03:53 PM
(21-07-2015, 08:29 PM)AlanBeckett Wrote: I'm sorry N-M but I'm even more confused.The bases are still there, yes. I had issues at first deciding whether to solder my silicon diodes to the base pins of the rectifier tube but, in the end, that's how I did it. All the other bases are fine. However, with regard to what you say about circuit wiring, the AGC decoupling capacitor had me baffled for close to 20 minutes when I was double checking it.
Terminology first: B7 is the old British 7-Pin Base. B7G is the modernish small 7-Pin Base. B9A is the modernish 9-Pin Base and Octal, of which there were two flavours, are 40s onwards 8-Pin Bases. There are Pictures on the national Valve Museum Website - http://www.r-type.org/search.php
Which are we talking about?
Are the Bases still in the Chassis? If so, what are they? A Picture would help.
If the Bases are missing then what size are the holes? If that's the case you're going to have some real fun deciding which wire goes where.
I have seen the odd Set where the Manufacturer fitted an 'Adapter Plate' in order to use a different Valve, but it's unusual.
Alan
The GEC radio is the BC5243. You can access the schematic on radio workshop.uk. 2nd page gives a clarification for the possible valves used. These are:
X61M X78 or X79 Mixer
W61, KTW61, W77 I.F. Amp
DH63 or DH77 Detector
KT61 or N78 output valve (I already fitted the N78)
I don't know why they didn't standardise but maybe somebody does have an explanation for that? I also noticed the valve data states the supply was 220 volts A.C. That had me curious and I was trying to find if 220 was standard in the early fifties.
I'll be ordering what I need tomorrow and the only possible doubt I have is between the W61 and W77.
I hope in the end it does work although it will never be the same radio and it's been more of a project than a restoration (something to learn on).







