30-04-2015, 06:19 PM
(This post was last modified: 30-04-2015, 06:21 PM by Old Sparky.)
I didn't think of using a Craft Knife, David, and I don't possess a Pillar Drill, so I drilled the holes, using a Hand drill and with the box clamped in a small bench vice. Not, perhaps, the easiest way to do it, but the only option open to me. I've often cut & drilled metal boxes & chassis that way, but seldom, if ever, plastic ones. At one time it was possible to buy 'Q' Max rectangular Cutters for metal, but not sure if they're still even made. As for scoring lines, it was just easier to do this on the outside of the box, rather than the inside, but why I ran that line all the way up the LH side I know not!
