26-10-2014, 02:07 PM
Hi Alan,
I've fitted a new cables using small tags to the ends of each roller connector and it was a very fiddly job indeed. I tried testing each valve pin connection using the set up for an Octal frequency changer valve as suggested in the http://www.kevinchant.com/uploads/7/1/0/...ester..pdf Avo tester manual and it appears that I have indeed wired correctly (fingers crossed). I shall take some pics of the work done so far but I'm process of reassembly.
I'm in two minds whether to replace the old resistors in the panel section as I would think that their restistance values will be very high by now. However, they are not in accessible positions to replace easily.
Regards
Rob
I've fitted a new cables using small tags to the ends of each roller connector and it was a very fiddly job indeed. I tried testing each valve pin connection using the set up for an Octal frequency changer valve as suggested in the http://www.kevinchant.com/uploads/7/1/0/...ester..pdf Avo tester manual and it appears that I have indeed wired correctly (fingers crossed). I shall take some pics of the work done so far but I'm process of reassembly.
I'm in two minds whether to replace the old resistors in the panel section as I would think that their restistance values will be very high by now. However, they are not in accessible positions to replace easily.
Regards
Rob
if all else fails...read the instructions!
