SE Labs Scope Repair

[Geaney]

I've been in the weeds with this project. Looks like someone previously did a lot of work on the channel amp modules and made a right mess. I've been finding dry solder joints, shorted wires, lifted pcb tracks, etc. I think I have it at a stage now where it is relatively stable with most of the nasty work sorted out. I can hopefully get back to finding the original fault now. Just to keep me motivated I lost a few days because of discrepancies between the manual and the actual circuit - nothing like putting the scope probe on the wrong test point and chasing ones tail trying to trace the signal flow.

Ho Hum, at least I went down with the flu a few days ago so I've had to take a break from it

Cheers, John