12-09-2014, 08:10 PM
Having fitted a 1N4007, with a 100 ohm surge limiting resistor in series, the no load HT voltage is 325v, measured with my DMM, and with 240vac from the mains supply. I therefore need to reduce the HT to somewhere around 200-220v, which, if I've calculated correctly, will need a 5watt 1800 or 2200 ohm resistor, the stated HT current being around 45mA according to the service sheet. No doubt a capacitor dropper would be better, or, of course a new rectifier valve, if one is available anywhere!






