04-09-2014, 08:59 AM
You can use PSU Designer II (available free from http://www.duncanamps.com/psud2/) to model the replacement of the AZ31 (60mA, 500Vrms max) by silicon - although I don't think that the AZ31 is directly supported by PSUD2, a similar equivalent tube may be used from the supported list.
PSUD2 is a great resource for this sort of thing - its use is pretty much standard in the audio design world.
EDIT: FWIW, if you buy pukka (rather than suspect cheap IN400x from eBay or a grab-box at a ham fest or whatever), I've never known one fail when operated within spec. - an 1N4007 here is well within its SOA.
EDIT: The P5A HT supply is derived directly from the mains (no isolation). It may be a nice thing to do to put in a 1:1 small xfrmr for safety.
PSUD2 is a great resource for this sort of thing - its use is pretty much standard in the audio design world.
EDIT: FWIW, if you buy pukka (rather than suspect cheap IN400x from eBay or a grab-box at a ham fest or whatever), I've never known one fail when operated within spec. - an 1N4007 here is well within its SOA.
EDIT: The P5A HT supply is derived directly from the mains (no isolation). It may be a nice thing to do to put in a 1:1 small xfrmr for safety.
sıʌǝɹq ɐʇıʌ `ɐƃuol sɹɐ
ʞɔıu
ʞɔıu







