27-01-2014, 12:28 PM
thank you very much Alan for the explanation
as i said i did not connect it to the radio circuit as i was scared that such a higher dc voltage might burn the tubes.....i'm going to use 500 ohms 10 watts resistor because the dropper resistor shown in the schematic is missing too...thanks alot
as i said i did not connect it to the radio circuit as i was scared that such a higher dc voltage might burn the tubes.....i'm going to use 500 ohms 10 watts resistor because the dropper resistor shown in the schematic is missing too...thanks alot
