22-01-2014, 02:09 AM
I have heated stuck screws of the tool blunting type found screwed into spring clips by putting a bit of soft steel rod in a high speed power drill and simply go flat out until the screw gets very hot and shatters the rust and then cut a slot in the melted end of the rod after stopping the drill while the thing is glowing hot.
The worst are the type that have a fake slot in them as well as a hex head. They even wreck sockets of the correct size after a couple of hundred of the things.
The worst are the type that have a fake slot in them as well as a hex head. They even wreck sockets of the correct size after a couple of hundred of the things.
