A Beast from Burton.

0 Vote(s) - 0 Average
1
2
3
4
5

A Beast from Burton.

Joe

No Longer a Member

Posts: 2,603
Location: Sheffield

01-12-2013, 04:53 PM

I made my brights by turning a blunt point on a ⅝" rod and then hammering annealed brass to shape over it. I then super-glued the brass to it and put it in the lathe to turn the edges true and polish the face side.

- Joe

Quote

Messages In This Thread

A Beast from Burton. - by Joe - 30-11-2013, 01:48 PM

RE: A Beast from Burton. - by ed731pdh - 30-11-2013, 01:50 PM

RE: A Beast from Burton. - by pwdrive - 30-11-2013, 02:52 PM

RE: A Beast from Burton. - by Yorkie - 30-11-2013, 03:59 PM

RE: A Beast from Burton. - by AlanBeckett - 30-11-2013, 04:43 PM

RE: A Beast from Burton. - by Joe - 30-11-2013, 05:06 PM

RE: A Beast from Burton. - by Retired - 01-12-2013, 04:21 PM

RE: A Beast from Burton. - by Joe - 01-12-2013, 04:53 PM

RE: A Beast from Burton. - by Retired - 01-12-2013, 05:10 PM

RE: A Beast from Burton. - by Bushbaby - 01-12-2013, 05:36 PM

RE: A Beast from Burton. - by AlanBeckett - 01-12-2013, 07:44 PM

RE: A Beast from Burton. - by Bushbaby - 01-12-2013, 07:59 PM

RE: A Beast from Burton. - by Yorkie - 02-12-2013, 07:18 PM

RE: A Beast from Burton. - by AlanBeckett - 01-12-2013, 08:26 PM

RE: A Beast from Burton. - by Joe - 01-12-2013, 11:14 PM

RE: A Beast from Burton. - by Bushbaby - 02-12-2013, 12:04 AM

RE: A Beast from Burton. - by Retired - 02-12-2013, 05:20 PM

Users browsing this thread:

1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me